Barco MatrixPRO-II 16×16

3G/HD-SDI High-Speed Serial Router

Mouse roll-over to zoom image.

Product Highlights

Supports SDI formats from SD formats to 3G/HD
Image switching and signal distribution without artifacts
Features a genlock input with loop through

Rentex No. RTR3G16XB | Mfr No. R9004660

The Barco MatrixPRO-II 16×16 Switcher with 3G SDI combines a high 600MHz bandwidth with a flat +/-1.0dB to 300MHz frequency to deliver image switching and signal distribution without any artifacts.

A genlock input synchronizes all switching with the house sync. A user-selectable RGB delay mode locks down-stream equipment to a new signal before anything is visible on the screen. And presets are available to be stored and allow easy system reconfiguration. I/O grouping and split-mode switching features divide the matrix into smaller sub-switchers and let each color channel switch independently.

Control can be by front panel buttons, by RS232, or via Ethernet connections. The switcher also fully integrates with Barco’s Encore and ScreenPRO-II presentation systems and can be controlled through them.

Rentex Spec R9004660

Barco MatrixPRO-II Series Specifications

Barco MatrixPRO-II Series User Guide

Supported Formats

DVB-ASI, SMPTE 259M, SMPTE 292M, SMPTE 424M; 270M bps – 2.97Gbps; 2K, 2048×1556/23.98 and 24

Inputs
Standard	SMPTE 259M / SMPTE 292M / SMPTE 424M
Data Rate	270Mbps – 1.485Gbps / 2.97Gbps
Connector	75 ohm BNC female
Impedance	75 ohm nominal
Return Loss	> 15dB (5MHz – 1.485GHz); > 10dB (1.5 – 3GHz)
Cable Equalization	Automatic up to 230′ (70m) @ 2.97Gbps, typical Belden 1694A Automatic up to 328′ (100m) @ 1.485Gbps, typical Belden 1694A Automatic up to 984′ (300m) @ 270Mbps, typical Belden 8281
Outputs
Connector	75 ohm BNC female
Impedance	75 ohm nominal
Return Loss	> 15dB (5MHz – 1.485GHz); > 10dB (1.5 – 3GHz)
Signal Level	800mVp-p ±10%
Rise & Fall	– 20 – 80% – SD limit: 0.4 – 1.5ns, < 0.5ns rise/fall variation – HD limit: < 270ps, < 100ps rise/fall variation – 3G-HD limit: < 135ps, < 50ps rise/fall variation
Amplitude Overshoot	< 10%
Signal Polarity	Non-inverting electrical with respect to inputs
Power & Other Parameters
Power	19W
Signal Speed	Timing jitter: SD: < 0.2 UI; 3G-HD/HD: < 1UI Alignment jitter: SD: < 0.2UI; 3G-HD/HD: < 0.2UI
Safety Regulations	Compliant with CE EN55103-1 and 2
Control	Serial port: RS-232, DB9 connector female Ethernet port: 10/100BaseT Ethernet bus, 1x RJ45 connector
Rack Mount	1RU
Dimensions	1.7 x 19 x 2″ (4.4 x 48.3 x 5 cm)
Weight	3.1 lbs (1.4 kg)